Vulcan SE, no acceleration (Full Version)

All Forums >> [RC Cars, Buggies, Trucks, Tanks and more] >> 1/16th, 1/18th, Mini & Micro RC Cars >> IRC Racing Support



Message


doh2doh -> Vulcan SE, no acceleration (8/30/2007 10:29:35 AM)

I have just bought two Vulcan SE. Both of them have no acceleration. I need to give them a push to get them going, then they slowly pick up speed until I turn, then they virtualy stop.
Any Ideas what could be causing this? I thought they might be stuck in second gear but what would cause that to happen on two brand new cars?
Any sugestions would be appreciated.




HimotoRacingUSA -> RE: Vulcan SE, no acceleration (8/31/2007 12:13:20 PM)

i dont know if the vulcan has a low speed needle on the engine, if your breaking it in, leave it alone, if your done then lean the low needle a little. actually watch these video's, all nitro engines get tuned the same.

http://youtube.com/watch?v=oSmMzpZM_As

http://youtube.com/watch?v=BJFsJAxNoRg




Mindcrime -> RE: Vulcan SE, no acceleration (8/31/2007 11:13:48 PM)

I would agree with ehroof, it sounds like they are both running very rich (this is a good thing for break in) you mentioned maybe they are stuck in second gear, did you put the 2 speed transmission on them? in stock from the have a single speed installed.




doh2doh -> RE: Vulcan SE, no acceleration (9/6/2007 8:10:54 AM)

They both came with the two speed transmition in when I purchased them.
I will try leaning out the bottom needle.
Thanks for your help.




bigairlife -> RE: Vulcan SE, no acceleration (12/8/2007 9:53:33 PM)

FINISH THE BREAK IN FIRST :) !!! lol




Page: [1]

Valid CSS!




SITE MAP!   : :   FORUM RULES

© 2001 - 2007 24-7 RC, LLC, all rights reserved.
6.46875