|
DeadSticker -> Venom NR3D and NR3D micro (9/1/2007 5:31:52 PM)
|
6 days ago I bought both of these helis. The reason I chose them is because I have been using venom products in my cars for years and I have been very pleased. I have been flying helis for the better part of a decade. From the sub micro ms hornets up to 90 size nitro birds and everything inbetween. When it says RTF, you would expect them to be ready to go right out of the box. That was not the case with either. With myself it was no problem getting them adjusted right, but for someone that has not fully setup a heli I could see that bring nothing but headaches. After about 3-4 days of tweeking, I finally got them both to fly great. But now I have another issue. The batt for the micro had a cell go bad after 6 flights, and the motor is really weak, to the point that after a full charge it would only hover about 5-6" off the ground. On the NR3D, the motor went bad after 9 flights. And that was with no aggresive flying on either one. Just hovering and FF. So to make a long story short, I'm going to pick up a axe cp and put the VNR3D on a shelf...Anyone else have problems like these?? Or did I just get some bad ones...
|
|
|
|
