Setup For Older Simple Smoke Pump (Full Version)

All Forums >> [Glow Engines, Gas Engines, Fuel & Mfg Support Forums] >> RC Fuels



Message

danmilo -> Setup For Older Simple Smoke Pump (3/19/2003 10:50:10 AM)

I have one of the older units, looks like a big rectangular pack of gum. I am trying to figure out how to wire it up. It has one radio lead on it. I imagine this would be hooked to a 4.8 volt battery with an on-off switch and a micro switch activated by a servo?

I visited TME's site and they had plenty of instructions on the II pump but it has two radio connections and plugs directly into the receiver.

Dan :rolleyes:



repinfl -> Setup For Older Simple Smoke Pump (3/23/2003 10:56:37 PM)

I have two of the "old" units and they both have TWO leads
coming from the unit. One is for the battery and the other plugs
into a spare channel in the receiver. It is activated at about 50%
of travel of that channel. If it does not activate try reversing the
channel. I also have the instruction manual for this pump and
could send You a copy if You feel it necessary.

Now it is possible that You have an even older model that does
not have two leads coming from it but I have never seen one like
that!

Robert



danmilo -> Setup For Older Simple Smoke Pump (3/24/2003 6:43:50 AM)

Thanks for your comments. Now that I am curious, I am going to pry open the case to see if one lead was removed. Would you mind mailing me a copy? I'll gladly cover your costs associated with the effort!

Dan



Page: [1]

Valid CSS!




SITE MAP!   : :   FORUM RULES

© 2001 - 2007 24-7 RC, LLC, all rights reserved.
0.078125