2S2P brick pack - pictures please (Full Version)

All Forums >> [Radios, Batteries, Clubhouse and more] >> Batteries & Chargers >> A123Racing Support



Message

SinCityJets -> 2S2P brick pack - pictures please (11/24/2007 3:05:20 AM)

I am building a 2s2P brick pack with A123 cells. Can someone please post a picture of both the top and bottom of the cells (all soldered up). I went to the scriptasylum website, but the eample shows the cells end to end. I do not have the capability to solder end to end, so I need to make a brick pack. I just don't want to short anything out!!

Thank you.




bobferguson -> RE: 2S2P brick pack - pictures please (11/24/2007 3:11:48 AM)

One way is to use solder braid to connect two cells side by side and then bend the braid so they are end to end. If that makes sense. When using dewalt packs I bend the connector end to end where I can. This save having to solder end to end. I have 8 packs done this way. they are 4 cell packs.

quote:

ORIGINAL: SinCityJets

I am building a 2s2P brick pack with A123 cells. Can someone please post a picture of both the top and bottom of the cells (all soldered up). I went to the scriptasylum website, but the eample shows the cells end to end. I do not have the capability to solder end to end, so I need to make a brick pack. I just don't want to short anything out!!

Thank you.






everydayflyer -> RE: 2S2P brick pack - pictures please (11/24/2007 3:35:23 AM)

Never mind









SinCityJets -> RE: 2S2P brick pack - pictures please (11/24/2007 4:23:29 AM)

Pictures would be greatly appreciated! I'm not very bright [&o]



Page: [1]

Valid CSS!




SITE MAP!   : :   FORUM RULES

© 2001 - 2007 24-7 RC, LLC, all rights reserved.
0.140625