Anyone using 5645's on 102" Yak Ailerons (Full Version)

All Forums >> [RC Airplanes] >> Giant Scale Aircraft - 3D & Aerobatic >> Quique's Aircraft Support



Message

bob_nj -> Anyone using 5645's on 102" Yak Ailerons (11/25/2007 3:32:58 PM)

Wondering if this is sufficient for dual servo ailerons?

Thanks
Bob



bob_nj -> RE: Anyone using 5645's on 102" Yak Ailerons (11/29/2007 5:52:52 PM)

Guess not [:-]



eraser -> RE: Anyone using 5645's on 102" Yak Ailerons (11/29/2007 10:21:18 PM)

Yes, I have. They seem strong enough, but are kind of slow, and in my opinion do not center that well. But for $45.00 ea???



bob_nj -> RE: Anyone using 5645's on 102" Yak Ailerons (11/29/2007 10:23:48 PM)

Thanks for the reply.
Are you using 6 volt?

What is your receiver and battery set up?


Happy Holidays
Bob



SukhoiKid -> RE: Anyone using 5645's on 102" Yak Ailerons (12/19/2007 10:39:03 PM)

I had some older ones in mine at first and was getting Major Blow Back. At first they did okay. It would take a while for the plane to get to its maximum rolling speed. But after while they just started getting major blow back. I replaced them with 5955. They do great. Troy Built Models for 85 dollars I believe if you buy more than one.



sethslasher -> RE: Anyone using 5645's on 102" Yak Ailerons (12/23/2007 3:27:10 PM)

I had Hitec 5945s on ailerons/elevators and was getting SERIOUS blowback on my Gen 1. Switched to 8611as and havent had any problems since!

Seth



Page: [1]

Valid CSS!




SITE MAP!   : :   FORUM RULES

© 2001 - 2007 24-7 RC, LLC, all rights reserved.
0.125