New edge 540T from CMP (Full Version)

All Forums >> [RC Airplanes] >> ARF or RTF >> NitroModels Support



Message

Maine_Flyer -> New edge 540T from CMP (12/10/2007 3:21:28 PM)

beautiful bird and a nice price as well.. if it flys as well as the 80"330L it should be a winner.. CMP Edge 540T this one should fly well on the same motor I have in my Extra330L-- FTL 45cc gasser from hobbycity.com-- cost effective setup to get you into giant scale ships on the cheap side..[;)]



Prop_Washer2 -> RE: New edge 540T from CMP (12/11/2007 12:52:22 AM)

I
believe in the cheap side...



opjose -> RE: New edge 540T from CMP (2/11/2008 7:27:23 PM)

The finish on mine is flawless.

Excellent covering.



opjose -> RE: New edge 540T from CMP (3/13/2008 4:39:15 AM)

Detailed pictures of interior and finished plane available on this thread: Click me!

The All Up Weight was EXACTLY as advertized, and the plane balanced perfectly at the indicated C.G. w/o any effort on my part.




snap232 -> RE: New edge 540T from CMP (3/21/2008 5:07:19 PM)

What engine are you guys using? I have been looking at the SV50 from hobby City? Anyone have any experience with that engine?

Thanks,

Ray



opjose -> RE: New edge 540T from CMP (3/21/2008 5:20:51 PM)

ZDZ50 NR in mine... though I have not flown the plane yet.

This engine produces very good HP, and I'm afraid it may be too much for this plane.

The 540T is smaller (but about the same weight) as my Giant U-Can-Do 3D, and the UCD only has a 4C 1.80 engine, which is larger than recommended.

Check the thread I indicated above.




Page: [1]

Valid CSS!




SITE MAP!   : :   FORUM RULES

© 2001 - 2007 24-7 RC, LLC, all rights reserved.
0.125