90LX muffler gasket? (Full Version)

All Forums >> [Glow Engines, Gas Engines, Fuel & Mfg Support Forums] >> Engine Manufacturers Direct Support Forum >> Jett Engineering Support



Message

thomp896 -> 90LX muffler gasket? (12/11/2007 2:45:13 PM)

Do I need to make a gasket for the 90LX muffler or is metal to metal ok? Probably a dumb question but you never know if you don't ask I guess. Thanks, Steve



bob27s -> RE: 90LX muffler gasket? (12/11/2007 2:57:54 PM)

Metal to metal is fine... the surfaces match up quite well.

Does not hurt to add a gasket though.

I believe Dub does have metal muffler gaskets for the 90 engines... drop him a quick note at jettengr@sbcglobal.net and see if he has some handy.

The engines/mufflers are supplied with gaskets

Bob



thomp896 -> RE: 90LX muffler gasket? (12/11/2007 10:52:03 PM)

Thanks for the quick reply. I don't think mine came with a gasket but now I'll recheck the box. If not I'll probably use some high temp gasket maker and call it good, Thanks again. Steve



bob27s -> RE: 90LX muffler gasket? (12/12/2007 2:23:34 PM)

very good....

usually the gasket is in a small package with two small jett decals and prop stud.



Page: [1]

Valid CSS!




SITE MAP!   : :   FORUM RULES

© 2001 - 2007 24-7 RC, LLC, all rights reserved.
0.171875