Thoughts on this charger for A123? (Full Version)

All Forums >> [Radios, Batteries, Clubhouse and more] >> Batteries & Chargers >> A123Racing Support

Message

---

jasonjax -> Thoughts on this charger for A123? (2/11/2008 1:23:54 AM) I saw this on the off-road electric forum and wanted to get some input an using this charger with a pack made from the Dewalt cells. http://www.****/hobbycity/store/uh_viewItem.asp?idProduct=6408 Apparently it is identical to the Hyperion EOS6I

---

simplecj -> RE: Thoughts on this charger for A123? (2/11/2008 6:40:22 AM) LiPo chargers aren't recommended for M1's. You can however use this with the Dapter chip sold here: The LiPoDapter+, Dapter for short... I just ordered one for about $30, says it can be used with most NiMh and LiPoly packs and has a mode for charging M1 cells specifically. Plenty of information there... I'm also building a couple packs from the DeWalt cells, can't beat $11 per cell shipped! Unless you buy more than one 36v DeWalt pack, then you might get them as low as $9 per cell if you're lucky, but probably more cells than you need.

---

Page: [1] 1

SITE MAP!   : :   FORUM RULES © 2001 - 2007 24-7 RC, LLC, all rights reserved.

0.078125