Wood props on SP series? (Full Version)

All Forums >> [Glow Engines, Gas Engines, Fuel & Mfg Support Forums] >> Engine Manufacturers Direct Support Forum >> RCV Engines Support



Message

buzzard bait -> Wood props on SP series? (2/17/2008 4:52:42 PM)

Is it possible to use wood props on the 2:1 geared RCV engines? I want to be able to use near-scale props on WWI types, but unless they are wood it will defeat the purpose. I heard the SPs need the mass of a composite prop, but wanted to make sure.

Thanks in advance,

Jim



andi3142001 -> RE: Wood props on SP series? (2/18/2008 8:53:45 PM)

Hello,

I used the APC prop recommended by RCV for the first 2 hours. Thereafter switched to a much lighter scale-like carbon prop. Works fine.

regards
Andi



RCV Engines -> RE: Wood props on SP series? (2/19/2008 1:06:52 PM)

Hi Jim

We always use and recommend glass composite propellers, however wooden propellers can be used if necessary and have been used in some RCV testing. It is important however to use good quality/heavier wooden propellers because generally wooden ones are too light and do not produce the flywheel effect. A point to note is that RPM figures will be lower when using wooden propellers.

Best regards

Stephanie



buzzard bait -> RE: Wood props on SP series? (2/20/2008 12:00:05 AM)

Thanks for the responses. I would use hard maple, not beech or any of the other lighter woods. Jim



Page: [1]

Valid CSS!




SITE MAP!   : :   FORUM RULES

© 2001 - 2007 24-7 RC, LLC, all rights reserved.
0.1400146