BEC hook up (Full Version)

All Forums >> [RC Helicopters] >> Electric RC Helis



Message

blk822 -> BEC hook up (3/7/2008 2:57:28 PM)

I'm working on building my hurricane 550 and the Rx I have has the battery port in the number 6 port( 6/B) And that port is for the pitch I beleive, and I need the have a BEC, so can I hook it into another port? My freind says I may be able to get a splitter and hook it up with a servo but he wasn't sure. Any I deas?



cactus hopper -> RE: BEC hook up (3/8/2008 7:01:48 AM)

What receiver, what ESC and what BEC?



blk822 -> RE: BEC hook up (3/8/2008 5:08:41 PM)

I have futaba 146ip Rx and a hurricane 550 ultrafly OEM 50amp, and a castle creations 10a bec



Flypaper 2 -> RE: BEC hook up (3/8/2008 11:15:27 PM)

If it's a Futaba trans., the bec should plug into the #3, throttle channel. I'd take the blades off till you get things worked out for safety purposes. Also the throttle channel on the Fut. has to be reversed.



Druss -> RE: BEC hook up (3/9/2008 12:36:31 AM)

hmm, if it's a separate ubec then the esc should still plug into the throttle channel and the bec can be split with a servo if no other slots are open.



blk822 -> RE: BEC hook up (3/9/2008 11:37:45 PM)

Yea I watched a finless Bob BEC101 video and you can pug it in to any port because all the ports have the + and - on a bus line between them all and then the signal wire is different on all the ports. So I have it all figured out now Thanks Guys.



Page: [1]

Valid CSS!




SITE MAP!   : :   FORUM RULES

© 2001 - 2007 24-7 RC, LLC, all rights reserved.
0.078125