Need info about 22e RX-603 reciver (Full Version)

All Forums >> [RC Helicopters] >> Electric RC Helis >> Walkera Helis - Dragonfly, etc..



Message


jcervantes11 -> Need info about 22e RX-603 reciver (3/10/2008 1:40:38 AM)

Hey guys I would like to use my walkera radio system with reciver all in one on a 6-channel black hawk 3d pro http://www.xheli.com/6blha3dproar.html.
It's like belt drivin type of plane and its a cp. I would like to know if i can use just reciver and not the built in stuff. Is it possible that theres a way to do that?
Has anyone used this receiver on a walkera belt drivin heli?




jtspin -> RE: Need info about 22e RX-603 reciver (3/10/2008 8:08:52 AM)

I don't think it can be done. The 22E Rx doesn't have a rudder output channel and you'll need that to control the tail servo. You should also know a few things about the Blackhawk 3D Pro: It was a great bargain at twice the price they're selling it at now. BUT... it's a clone of the Century Elite 3D Pro which has been discontinued. Spare parts are pretty much impossible to get. Also, it's not a belt drive tail, but a shaft drive tail. It eats crown gears any time the tail rotor hits anything (and I mean anything). Some parts from the Skyartec Mosquito Pro will fit it, but not all of them. I'm not saying don't get one, but if you do you might want to get two or three so you'll have some spare parts.

-JT




jcervantes11 -> RE: Need info about 22e RX-603 reciver (3/10/2008 8:17:04 AM)

I'm thinking about now changing my mind and get myself a ESKY Honey Bee CP2 Heli ARF 35 bucks just to mess around with since all i need to do is install walkera
receiver, servos and adjust. I just want something easy and stupid to work on with cheap price. I'm about to get soon a 450 heli and also have a helimax axe cp.
Why let walkera radio colecting dust if cheap kits are availble. Oh also another quetion is there a way this receiver would work as just a regular four channel
radio system? For a fixed pitch? I need all the resource i can get guys. Bad things i just baught crystal from ebay 5 dollar shipped. :) Its a good thing I guess.
The fact i like my radio because it has all the nobs and switches. Any ya guys know any cp kits under 70 dollars????




GTX SlotCar -> RE: Need info about 22e RX-603 reciver (3/10/2008 2:27:21 PM)

I'm not sure your Tx will work properly on other helis. It's not programmable, so there is no way to adjust the swash movement, centering (% of travel), and servo direction for eCCPM helis. It's pre-set for your 22E. I know that you can reverse servo direction for the cyclic, but that's not the same as changing it for CP on the swash.
If it does work right, I'd say that would be very lucky.





Page: [1]

Valid CSS!




SITE MAP!   : :   FORUM RULES

© 2001 - 2007 24-7 RC, LLC, all rights reserved.
0.109375