glow plug (Full Version)

All Forums >> [Glow Engines, Gas Engines, Fuel & Mfg Support Forums] >> Engine Manufacturers Direct Support Forum >> Jett Engineering Support



Message

phjoker -> glow plug (3/13/2008 12:34:47 AM)

How would the mccoy #9 glow plug work for the jett 90 Lx's?
Just curious...I have some and was wondering if they would be OK
or not..



bob27s -> RE: glow plug (3/13/2008 2:17:15 PM)

Well... give it a try if you have one on hand.

That plug is on the cold side. The top end will be fine --- comes down to the midrange and transition. If you are satisfied there there should be no problem.

Resist the temptation to lean out the low end needle (no more than 1/8 turn from its current position if you can not resist) if it tends to load up a bit too much through midrange.



Page: [1]

Valid CSS!




SITE MAP!   : :   FORUM RULES

© 2001 - 2007 24-7 RC, LLC, all rights reserved.
0.0625