Jtec Muffler Help (Full Version)

All Forums >> [RC Airplanes] >> Giant Scale Aircraft - 3D & Aerobatic >> JTEC / RADIOWAVE Support



Message

qwazzy123 -> Jtec Muffler Help (3/13/2008 10:27:16 PM)

Hi All,
I ordered wrap around muffler for my OS 120AX. I did't see this in the picture on their web site, but when the muffler showed up, I noticed there is no negative pressure nipple to push air pressure back in to the gass tank. My question is obviously, how do I set up the gas tank with out pushing air pressure back into the tank.

Every glow engine I had so far has a nipple that put pressure back into the gas tank.

Here is a link to the muffler.

http://www.jtecrc.com/oswraparound.htm

Thanks



jtec radiowave kid -> RE: Jtec Muffler Help (3/14/2008 4:33:18 PM)

Generally we do not put pressure taps in our mufflers because everyone has there own idea of where they would like it and how it will work for there specific application. What we tell most people to do is put the pressure tap on the flat header portion of the wrap around pitts muffler around the exhaust port and use the pressure tap from the original muffler that came with the engine or get a dubro 6-32 pressure tap.



qwazzy123 -> RE: Jtec Muffler Help (3/14/2008 8:30:48 PM)

So can I just drill a hol that is smaller the then the thread and literally thead the presure tap right into the muffler??



jtec radiowave kid -> RE: Jtec Muffler Help (3/14/2008 11:09:49 PM)

I would do it with your typical 6-32 drill and tap that you can get from a hardware store or a hobby shop.



qwazzy123 -> RE: Jtec Muffler Help (3/14/2008 11:57:25 PM)

Forgive my ignorance, I guess I don't know what a tap is. Is this something you use to make a thread in the hole so you can screen the pressure nib into. Sorry, just never don't this and new terminology for me.



al -> RE: Jtec Muffler Help (3/17/2008 12:34:41 AM)

Yes,

You should be able to pick it up at your local hobby shop. Dubro makes a drill and tap set(thread maker) for a couple bucks. If they don't have it lowes or Homedepot

Al



Page: [1]

Valid CSS!




SITE MAP!   : :   FORUM RULES

© 2001 - 2007 24-7 RC, LLC, all rights reserved.
0.140625