seeking rail dragster plans for 1/8th scale build (Full Version)

All Forums >> [RC Cars, Buggies, Trucks, Tanks and more] >> RC Drag Racing



Message

PROSTOCK68 -> seeking rail dragster plans for 1/8th scale build (3/16/2008 2:59:51 PM)

im looking for anyone or anywhere i can get a full scale tubing frame with a scale aluminum body with twin 4 strokes, old school ft engines rail is what im looking for even full scale i can shrink down thanks guys.



2916jr -> RE: seeking rail dragster plans for 1/8th scale build (3/16/2008 5:51:58 PM)

there are no plans you make your own



PROSTOCK68 -> RE: seeking rail dragster plans for 1/8th scale build (3/16/2008 6:06:23 PM)

NICE...... i see where a guy here bought a set of funny car plans from mark williams, and they arrived in 1/8th scale, ill call them in the am see if there rail plans are in the same 1/8th scale... start from there id love to do a set of 4 saito 4 strokes hooed in pairs side by side with stright zoomy pipes.... [:D]



boomhower -> RE: seeking rail dragster plans for 1/8th scale build (4/4/2008 8:38:33 PM)

I design cars for a fee. Here's a pic of the front part on one, im' building now in a 3-d model, and a mock up of the rear half. LMK how long, wide, size of motor, what type of tranny, etc...



FirestormBasher -> RE: seeking rail dragster plans for 1/8th scale build (4/4/2008 9:23:57 PM)


quote:

ORIGINAL: boomhower

I design cars for a fee. Here's a pic of the front part on one, im' building now in a 3-d model, and a mock up of the rear half. LMK how long, wide, size of motor, what type of tranny, etc...

Boom, where do you get your diff housings, and internals, and the drive shafts?



2916jr -> RE: seeking rail dragster plans for 1/8th scale build (4/4/2008 9:30:09 PM)

those are cen housings and drivetrain



FirestormBasher -> RE: seeking rail dragster plans for 1/8th scale build (4/4/2008 9:34:07 PM)

Cool but what model are those directly from?



boomhower -> RE: seeking rail dragster plans for 1/8th scale build (4/5/2008 10:15:29 AM)

The diff is from a Nemesis, that I gutted out and made my own spool, and axel shaft. The plastic drive shaft is from a GST, but I have changed it since that pic and went with the Nemesis steel dogbone drive shaft. I'll take a pic at work today of the front half finished now, and post it tonight.



Page: [1]

Valid CSS!




SITE MAP!   : :   FORUM RULES

© 2001 - 2007 24-7 RC, LLC, all rights reserved.
0.125