JR X9303 Gyro Gain Rx Channel for HG-5000 (Full Version)

All Forums >> [Radios, Batteries, Clubhouse and more] >> RC Radios, Transmitters, Receivers, Servos, gyros >> Radio Manufacturer Direct Support >> Hitec/MultiPlex Radios- Ask Hitec Customer Service

Message

---

smarks -> JR X9303 Gyro Gain Rx Channel for HG-5000 (3/27/2008 10:10:32 PM) Mike - Do you know what Rx channel I need to plug the HG-5000 gyro gain lead into on a JR X9303? Thanks!

---

MikeMayberry -> RE: JR X9303 Gyro Gain Rx Channel for HG-5000 (3/31/2008 8:35:26 PM) It should be channel #5. Mike.

---

smarks -> RE: JR X9303 Gyro Gain Rx Channel for HG-5000 (3/31/2008 8:50:58 PM) That is what I read in the setup manual for the 5000, but then reading the 9303 manual it says AUX2, which would be channel 7. I currently have it plugged into Ch5 since I am using a 6 channel Rx and don't even have a 7th channel. It appears to work ok, I think. When I flip the gear switch (Ch5) I can change the gyro from TL to Rate. I can then adjust the gain value by changing the subtrim for Ch5. Should that work ok you think? I can't think of any other way to do it unless I use a 7 channel Rx.

---

MikeMayberry -> RE: JR X9303 Gyro Gain Rx Channel for HG-5000 (3/31/2008 9:26:11 PM) That sounds like it should be fine. Mike.

---

smarks -> RE: JR X9303 Gyro Gain Rx Channel for HG-5000 (3/31/2008 11:35:09 PM) Thanks Mike! [:D]

---

Page: [1] 1

SITE MAP!   : :   FORUM RULES © 2001 - 2007 24-7 RC, LLC, all rights reserved.

0.109375