MT e325 SE Tail Jumping (Full Version)

All Forums >> [RC Helicopters] >> Electric RC Helis



Message

ELC -> MT e325 SE Tail Jumping (3/29/2008 8:19:04 AM)

MT e325SE , during hover the tail at times starts to
move up & down. The rotors track right on, also
balanced with CG location dead on. The heli
balance seams to be OK.
What am I missing?
Spectrum Dx7, Gyro 401, Rx 6100, ccpm servos DS285,
Tail F9257, the rest Kit supplied.
Need some input.
Thanks.[/font][/size][



cactus hopper -> RE: MT e325 SE Tail Jumping (3/29/2008 12:22:30 PM)

I'd suspect a bad elevator servo or slop in the linkage.



ELC -> RE: MT e325 SE Tail Jumping (3/29/2008 3:50:26 PM)

Good answer Cactus will check.



simplyraptor -> RE: MT e325 SE Tail Jumping (3/30/2008 7:24:57 PM)

Try increasing your head speed, if it is too slow you will get the nodding motion



ELC -> RE: MT e325 SE Tail Jumping (3/30/2008 8:26:53 PM)

Simply--I presume that can be done at the Tx ?
Thx for the info.



simplyraptor -> RE: MT e325 SE Tail Jumping (3/31/2008 7:23:55 PM)

Yes, you adjust your throttle curve on your Tx, for example if your throttle curve at mid stick is set at 55% try moving the setting to 60%.

Have you set your curves as per manual or are your curves set at 0,25,50,75,100 ?????



Page: [1]

Valid CSS!




SITE MAP!   : :   FORUM RULES

© 2001 - 2007 24-7 RC, LLC, all rights reserved.
0.203125