I cannot program the Hitec 5645 servos (Full Version)

All Forums >> [Radios, Batteries, Clubhouse and more] >> RC Radios, Transmitters, Receivers, Servos, gyros >> Radio Manufacturer Direct Support >> Hitec/MultiPlex Radios- Ask Hitec Customer Service



Message

crazycap -> I cannot program the Hitec 5645 servos (4/1/2008 2:38:44 AM)

Hello

I have the Hitec HFP-10 Servo Tester, I can program the 5955 servo but I cannot program none of the 4 new 5645MG servos
When I try to reset the servo, after I push the input button several times comes out a FAIL message, the 4 four servos works ok but I cannot program any fucions, it seems that the programmer is not able to communicate with the servo.



Thanks



MikeMayberry -> RE: I cannot program the Hitec 5645 servos (4/1/2008 7:48:46 PM)

Are you trying to program through an extention? Do any of the other functions work?

Mike.



crazycap -> RE: I cannot program the Hitec 5645 servos (4/2/2008 1:47:51 AM)

No extension, the servo plug direct to the programmer.

The programmer fails to "find" the servos when searching to do any advanced programming like reset, speed, dband, cw/ccw etc.
It just says "searching" for a couple of seconds and then seems to reboot, as the screen flickers etc.





MikeMayberry -> RE: I cannot program the Hitec 5645 servos (4/11/2008 8:03:28 PM)

Sorry for the delay in this reply as I have been out of town.

It's tough to say what the problem could be. How old is the programmer?

Mike.



Page: [1]

Valid CSS!




SITE MAP!   : :   FORUM RULES

© 2001 - 2007 24-7 RC, LLC, all rights reserved.
6.201172E-02