QJ-2 Question (Full Version)

All Forums >> [Glow Engines, Gas Engines, Fuel & Mfg Support Forums] >> Engine Manufacturers Direct Support Forum >> Jett Engineering Support



Message

YUKONFLYR -> QJ-2 Question (4/1/2008 5:15:47 PM)

Hi - I was wondering why the cylinder head on the QJ-2 sits so high off of the top of the of the engine case? Looking at the website photo shows the cylinder head near the top fins of the case, and the picture of my engine shows the cylinder head with a considerable gap between the head and engine block. Is this an optical illusion or did I miss something? Maybe a product improvement?

Below is the pic off of Jett Website and the pic of my engine.

Thanks




bob27s -> RE: QJ-2 Question (4/1/2008 5:39:52 PM)

Yours is correct. [:D]

My picture isn't the latest model.

It is a design feature to keep the liner perfectly round and stable at temperature.



YUKONFLYR -> RE: QJ-2 Question (4/1/2008 6:11:17 PM)

Ok, I figured it to be an improvement[:D]

Thanks for the quick reply and the answer.

Richard



Page: [1]

Valid CSS!




SITE MAP!   : :   FORUM RULES

© 2001 - 2007 24-7 RC, LLC, all rights reserved.
0.0625