Accu-Cycle Pro for DX6I TX (Full Version)

All Forums >> [Radios, Batteries, Clubhouse and more] >> Batteries & Chargers



Message

hammerd -> Accu-Cycle Pro for DX6I TX (4/16/2008 9:06:29 PM)

I have the Accu-Cycle Pro, not Elite, and Spektrum DX6I radio. The TX only uses 4 cells and the chargers' TX side is designed for more cells (6, 7, or 8).
Is there any way to use the TX side for cycling/charging the Spektrum TX?
Thanks.



thesouth1 -> RE: Accu-Cycle Pro for DX6I TX (4/19/2008 8:40:44 PM)

I have the same problem. So I got a Hangar 9 Sure Cycle cause I have so many 4-5 cell batt. But you cannot cycle or charge the DX6i because of the diode in the circuit. I just took a 4 cell battery holder from my T-Maxx and use it to charge and cycle my Tx batt.



thesouth1 -> RE: Accu-Cycle Pro for DX6I TX (4/19/2008 11:24:43 PM)

I just modded my Tx so that I can charge it from my charger (Accu-cycle or the Sure-cycle) also this will void the warranty. I opend the case and looked at the charge reciptical and where you put the batterys and thought "why not run a wire from there to there". So I fired up the solder gun and went to work. Now I can plug in my charger to the port and it actually charges now [:D]



Page: [1]

Valid CSS!




SITE MAP!   : :   FORUM RULES

© 2001 - 2007 24-7 RC, LLC, all rights reserved.
0.078125