MCR 960 Question (Full Version)

All Forums >> [Radios, Batteries, Clubhouse and more] >> Batteries & Chargers >> MRC Charger Product Support (i.e. Super Brain, etc)



Message

slawhammer -> MCR 960 Question (4/17/2008 4:15:46 PM)

Ok..Some how my question got deleted...
I charge AA'S in a 4 cell holder..Just hit start button and charger does the rest..
A friend said use your transmiter tray to due 8 AA'S just hook up the clip and charge@1amp..I do not know how too figure mill amps
But would like too know...My friend recomended these settings...Glow Igniter @.5 amp 4 AA'S @1amp Hump pac @2 Amps...
I would like too due all 8 AA's for the transmiter at once..
I would like any suggestions on this..Thank You Roger



guver -> RE: MCR 960 Question (4/17/2008 4:24:08 PM)

Hmm, so did my response. [X(]

Anyways, the 960 won't care if there's 4 cell or 8 cells. 1 amp is what I'd consider max rate for small AA radio batts.

To figure milliamp multiply amps by 1000.



slawhammer -> RE: MCR 960 Question (4/17/2008 4:32:52 PM)

Thank You...Would it be better to charge by mill amps..slow long charge..
Guver.. No I did not get a responce from you till now in forum..


PS ..Just woundering do you have to discharge these nicad's to zero before recharging?
My friend you should ..some thing about 1/2 charge issue.

Thanks again
Roger



guver -> RE: MCR 960 Question (4/17/2008 4:51:17 PM)

Yes, it is better for the batteries. It just takes longer and it is unessecary to discharge. SINCe you have a peak charger then just charge them up from whatever level they are. (the 960 works well as a fast charger, and may time out on a slow charge)



Page: [1]

Valid CSS!




SITE MAP!   : :   FORUM RULES

© 2001 - 2007 24-7 RC, LLC, all rights reserved.
0.078125