EQ10 issue? (Full Version)

All Forums >> [Radios, Batteries, Clubhouse and more] >> RC Radios, Transmitters, Receivers, Servos, gyros >> Radio Manufacturer Direct Support >> Smart-Fly (Quest Engineering) Support Forum



Message

DCGayhart -> EQ10 issue? (4/20/2008 9:51:48 PM)

I’m having an issue with the throttle setup in my Yellow P-38 Lightning. I believe I have pinpointed the problem to the EQ10. This is my second EQ10 so I am familiar with its operation. I have the right engine on channel 1-a and the left engine on channel 1-b. During my initial setup the b-servo was acting funny, it would have trouble finding the center of the movement, IE it would hunt a little after stopping. I assumed it was a bad servo and replaced it. Today I was readjusting the low-end endpoint to synchronize the engines idle. I did the a-servos checking the engine RPM then switched the function dial to the b-servo doing the same. When I switched the function dial back to the a-servo the b-servo quite working completely. I manually rotated the servo arm and it was as if the servo was unplugged. I turned the channel and function dials to 0 and recycled the power switch and all was well again. Now I am worried! Do you think I have a problem with the new EQ10?

My other EQ10 is in a Composite ARF 2.6 Yak and worked great for two years. The EQ10 in my P-38 I won at the pilots raffle at the Speedworld Jet Meet this last winter. I’m leaving for the Joe Nall meet in 9 days. I could pull the EQ10 from my Yak but that would require setting up both all over. HELP!!

Danny



rrritchey -> RE: EQ10 issue? (4/20/2008 10:08:17 PM)

Hi Danny,
I think you are seeing a small bug that occurred in the second batch of Eq10s where the servo priority mode is always on. With it on, when you are adjusting the A servo, B will be turned off. If you go to B then A will be on. This has bothered very few people. If you like I can send you a revision where the servo priority can be set as per the manual.



DCGayhart -> RE: EQ10 issue? (4/20/2008 11:28:33 PM)

What does this involve?

Danny



rrritchey -> RE: EQ10 issue? (4/21/2008 3:26:10 PM)

Hi Danny,
I am not sure what you mean. If you want me to send you another unit e-mail me privately here or at info@Smart-Fly.com with your address and phone.



DCGayhart -> RE: EQ10 issue? (4/25/2008 4:42:25 PM)

I got the new unit the next day and installed. What great customer service! Thanks Robert.



Page: [1]

Valid CSS!




SITE MAP!   : :   FORUM RULES

© 2001 - 2007 24-7 RC, LLC, all rights reserved.
0.09375