version 1.04 5955's and futaba fasst..ok?? (Full Version)

All Forums >> [Radios, Batteries, Clubhouse and more] >> RC Radios, Transmitters, Receivers, Servos, gyros >> Radio Manufacturer Direct Support >> Hitec/MultiPlex Radios- Ask Hitec Customer Service



Message


JEFFRO503 -> version 1.04 5955's and futaba fasst..ok?? (4/21/2008 5:19:04 PM)

Hey guys.....

I'm building up a 35% Sukhoi , and have 5955's going every where on every surface ( 8 total + a hitec 525-HB on throttle )

I also have the older futaba 9Z TX that i just picked up the new TM-8 fasst mod for it.

I have only bought 4 of the 5955's , but it's been about 6 months or so , soooo , i don't know if they are the older version which has problems with the fasst system.

The numbers on the little round sticker on my 5955's say " 1.04".......not sure if this is a date or something , or possibly a version number.

how do i find out if i have the correct updated servo's??

OH YEAH.....and i also have the SF power expander pro in which i was planning on using as well.




MikeMayberry -> RE: version 1.04 5955's and futaba fasst..ok?? (4/21/2008 6:31:53 PM)

There is no way to tell without testing them.

If you are concerned then you might want to just send them in and we'll check them out.

Mike.




JEFFRO503 -> RE: version 1.04 5955's and futaba fasst..ok?? (4/21/2008 7:58:10 PM)

Hey Mike , i have no problem sending them in for an upgrade , but how do i go about doing this? Can i get an address , or possibly a service address to send them in? Also....what do i do about paying for the upgrade....do i just send a check with the servos?




MikeMayberry -> RE: version 1.04 5955's and futaba fasst..ok?? (4/21/2008 9:29:28 PM)

Here's theservice form: http://www.hitecrcd.com/Support/service%20form.pdf

There's no charge if they need to be updated.

Mike.




JEFFRO503 -> RE: version 1.04 5955's and futaba fasst..ok?? (4/21/2008 10:23:07 PM)

Ok thank you mike , i will get this thing filled out , and send them in. Thanks again for your help.


jeff




furloughed ual -> RE: version 1.04 5955's and futaba fasst..ok?? (4/26/2008 7:35:16 PM)

Mike, what's the approx turnaround time to upgrade some servos....I have some compatability issues also.....U listening Futaba?????




jonkoppisch -> RE: version 1.04 5955's and futaba fasst..ok?? (5/20/2008 5:35:00 PM)

I just ran across some 5645's that wont work with the 14 channel fasst....

AArrrrgggg!!!!!




Page: [1]

Valid CSS!




SITE MAP!   : :   FORUM RULES

© 2001 - 2007 24-7 RC, LLC, all rights reserved.
0.140625