main shaft

main shaft (Full Version)

All Forums >> [RC Helicopters] >> Electric RC Helis >> Walkera Helis - Dragonfly, etc..

Message

scouse-1 -> main shaft (4/26/2008 6:37:05 PM)
Hi Guy,s just a small question for anyone out there, just put the cnc metal head onto my walk-60, problem is there is now about an 1/8 inch movement of main shaft up and down!!, im sure this should not happen anyone know how to resove this cheer,s!.

robtangie -> RE: main shaft (4/26/2008 7:14:02 PM)
The locking nut between the swash plate and the topmost bearing. Loosen the set screw, pull the shaft up, push the locking nut down against the bearing and tighten the set screw again. This should solve your problem.

Page: [1]

0.046875