Question about AR6200 and servos (Full Version)

All Forums >> [Radios, Batteries, Clubhouse and more] >> RC Radios, Transmitters, Receivers, Servos, gyros >> Radio Manufacturer Direct Support

Message

---

IFlySlowPlanes -> Question about AR6200 and servos (4/26/2008 6:50:54 PM) This may seem like a dumb question, but I can't figure out which way to plug in my servos to this Rx. There's nothing I could find in the manual indicating which way the signal wire should be when the servo is plugged in. I'm used to Futaba Rx's where they indicate this for you. Would welcome any guidance!

---

Ugo Ferrari -> RE: Question about AR6200 and servos (4/26/2008 7:10:23 PM) Black wire Down...Yellow wire UP !

---

BarracudaHockey -> RE: Question about AR6200 and servos (4/26/2008 7:44:01 PM) They only work one way and it wont hurt them the other way.

---

Page: [1] 1

SITE MAP!   : :   FORUM RULES © 2001 - 2007 24-7 RC, LLC, all rights reserved.

0.0625