Bolts for the back plate on a SJ-50

Bolts for the back plate on a SJ-50 (Full Version)

All Forums >> [Glow Engines, Gas Engines, Fuel & Mfg Support Forums] >> Engine Manufacturers Direct Support Forum >> Jett Engineering Support

Message

thebluemax -> Bolts for the back plate on a SJ-50 (4/26/2008 9:19:03 PM)
Hi Bob, While flying my Bobcat with an SJ-50 on it, one of the bolts for the rear backplate came out. What size bolts are these? Thanks, Bill

bob27s -> RE: Bolts for the back plate on a SJ-50 (4/28/2008 2:14:15 PM)
Hi, Thanks for writing..... I am PRETTY sure the bolts are all 5-40. I know the head bolts are. Been a while since I checked on the backplate.... Bob

thebluemax -> RE: Bolts for the back plate on a SJ-50 (4/29/2008 5:05:05 AM)
Hi Bob, Thanks for the quick response. I did check the others and they are tight but I will need to get one to replace the missing one and maybe a spare or two. I will e-mail Dub.... Bill

Page: [1]

SITE MAP! : : FORUM RULES

© 2001 - 2007 24-7 RC, LLC, all rights reserved.

0.0625