Servo mounting on Trex 450 se v2 (Full Version)

All Forums >> [RC Helicopters] >> Electric RC Helis >> T-Rex heli



Message

quattro1975 -> Servo mounting on Trex 450 se v2 (4/27/2008 3:49:01 PM)

I was wondering how most people install/mount their servos on the 450 SE V2. When I got mine, they were mounted with the screws that are included, 5mm allens course threads for plastic plastic. They were screwed into little plastic tab-like nuts on the inside of the frame. I'm not crazy about this since they aren't as tight as I think they should be. What do you all use? is there anything we can use to tighten the grip within a plastic mount? like locktite for plastic. thanks for any input.
quattro



Skarn -> RE: Servo mounting on Trex 450 se v2 (4/27/2008 3:55:47 PM)

I installed mine with the plastic tabs as well and haven't had any issues whatsoever.

Skarn



Flying Foot Doc -> RE: Servo mounting on Trex 450 se v2 (4/27/2008 3:58:14 PM)

check out the build videos by Finless Bob. Lots of answers and helpful advice. Doc



quattro1975 -> RE: Servo mounting on Trex 450 se v2 (4/27/2008 4:05:32 PM)

OK...I just the Finless video on servo installation. I did it about the same way...so I'm cool on the actual install. However, the grommets or servo nuts, did not come with my new servos....shouldn't an hs65-hb come with those nuts? where do you get them?
quattro



Burntt32 -> RE: Servo mounting on Trex 450 se v2 (4/28/2008 1:28:17 AM)

they came in my 450 se v2 kit with the self tapping screws. they didn't come with the servos



rftusa2008 -> RE: Servo mounting on Trex 450 se v2 (5/7/2008 7:46:29 PM)

First I used the rubber grommet to secure the servos. That came loose so I used my spare servo arms, cut it up to fit and used it as a nut to secure the servos. Works well for me.



Page: [1]

Valid CSS!




SITE MAP!   : :   FORUM RULES

© 2001 - 2007 24-7 RC, LLC, all rights reserved.
0.109375