Whick Power Expander to Use with new JR 12X (Full Version)

All Forums >> [Radios, Batteries, Clubhouse and more] >> RC Radios, Transmitters, Receivers, Servos, gyros >> Radio Manufacturer Direct Support >> Smart-Fly (Quest Engineering) Support Forum

Message

---

Bobby Folsom -> Whick Power Expander to Use with new JR 12X (4/27/2008 10:42:41 PM) Robert, the new JR 12X comes with a R1221 12-ch 2.4 GHz receiver. Which one of your PE/regulators should be used with the R1221? Thank you for responding. Bobby

---

rrritchey -> RE: Whick Power Expander to Use with new JR 12X (4/27/2008 11:07:34 PM) Hi Bobby, I have not seen this receiver yet but it should work just fine with the PowerExpander MZ. There is nothing about the MZ that is Futaba specific. We will be coming out with a new PowerExpander 12 channel with Ignition Cutoff and a new PowerSystem 12 channel similar to the PowerSystem Eq6 versions but with no servo matching. These probably will not be out until mid summer though. Let me know if I can be of any further assistance.

---

Bobby Folsom -> RE: Whick Power Expander to Use with new JR 12X (4/28/2008 12:26:16 AM) Thanks Robert, that WAS a quick response!! I'll take a look at the PE MZ when my 12X shows up sometime next month and go from there. Bobby

---

Page: [1] 1

SITE MAP!   : :   FORUM RULES © 2001 - 2007 24-7 RC, LLC, all rights reserved.

0.0625