servo's wont respond!! (Full Version)

All Forums >> [RC Cars, Buggies, Trucks, Tanks and more] >> RC Car Radio Equipment



Message

MATT55 -> servo's wont respond!! (5/1/2008 2:36:15 AM)

i have a spektrum dx 2.0 and i did the quick setup in the instructions and the servos arent responding..

please help!



systemlord -> RE: servo's wont respond!! (5/1/2008 3:14:57 AM)


quote:

ORIGINAL: MATT55

i have a spektrum dx 2.0 and i did the quick setup in the instructions and the servos arent responding..

please help!

Do you have modulation modes from which to choose from? My Futaba radio has three modulation modes (PCM, HRS PPM) one of which is PCM, the servos don't respond because the receiver doesn't support PCM. Hope this helps.



MATT55 -> RE: servo's wont respond!! (5/1/2008 3:27:53 AM)

well now whenever i turn the wheel on the radio it starts to steer then the LED on the receiver turns off, and the throttle barle nudges and does the same



systemlord -> RE: servo's wont respond!! (5/1/2008 3:54:36 AM)


quote:

ORIGINAL: MATT55

well now whenever i turn the wheel on the radio it starts to steer then the LED on the receiver turns off, and the throttle barle nudges and does the same

It seems like your radio is loosing signal shortly after you move a servo or your batteries are low causing the receiver to activate the fail safe feature. My receiver has a little botton on it for resetting or re-aquiring the signal. Check your battery voltage.



nomobux -> RE: servo's wont respond!! (5/1/2008 12:05:03 PM)


quote:

ORIGINAL: MATT55

well now whenever i turn the wheel on the radio it starts to steer then the LED on the receiver turns off, and the throttle barle nudges and does the same

Low batt



MATT55 -> RE: servo's wont respond!! (5/2/2008 1:15:31 AM)

thats what was wrong, now another question

my throttle isnt working now, it moves only when i hit the brake and it still barley moves then



nomobux -> RE: servo's wont respond!! (5/2/2008 2:08:49 AM)

reverse the throttle/ brake servo setting on the transmitter



systemlord -> RE: servo's wont respond!! (5/2/2008 2:31:50 AM)


quote:

ORIGINAL: MATT55

thats what was wrong, now another question

my throttle isnt working now, it moves only when i hit the brake and it still barley moves then

You need to find the neutral or middle point in the servo, to do this you need to have both Tx & Rx turned on. It barely moves because its already at it full turn to the left or right, some servos can't turn 360% degrees. My servos only can do 90% grees turnning left to right.



savtraxx -> RE: servo's wont respond!! (5/2/2008 12:31:20 PM)

servo not busted?



Page: [1]

Valid CSS!




SITE MAP!   : :   FORUM RULES

© 2001 - 2007 24-7 RC, LLC, all rights reserved.
0.21875