OS Open rocker 60 parts and manual (Full Version)

All Forums >> [Glow Engines, Gas Engines, Fuel & Mfg Support Forums] >> Glow Engines



Message

mike109 -> OS Open rocker 60 parts and manual (5/2/2008 7:18:59 AM)

G'day from Oz

Does anyone know where I might find a pushrod and the Manual / Parts list for an OS open rocker 60 four stroke. It is serial number 22660 and I have just bought it from a certain auction site. It is in really nice condition but sadly it was damaged in transit and one of the pushrods was bent. I have straightened it but I would like to find a new rod if I can. The parts list would allow me to see it is a common part with some later models. I am hoping to put it in a Dallaire Sportster from 1938 for a bit or RC assisted free flight. Thanks.



Patxipt -> RE: OS Open rocker 60 parts and manual (5/2/2008 9:42:30 AM)

Usually, when a pushrod gets bent on an open-rocker, it subsituted with a piece of piano wire of the same diameter, nothing else!



mike109 -> RE: OS Open rocker 60 parts and manual (5/2/2008 11:38:03 AM)

G'day That was my fallback position if I could not find a genuine part. It should be quite easy to make as the length is not critical thanks to the adjustment available. I would still like a copy of the manual if someone can point me at one.



iflyj3 -> RE: OS Open rocker 60 parts and manual (5/2/2008 12:08:35 PM)

Send me an email or PM with your email addy and I will send some data I have. I have the 75 manual which is similar to the 60 and a magazine review of the engine. I have the 60 manual somewhere but it is not scanned.



Patxipt -> RE: OS Open rocker 60 parts and manual (5/2/2008 12:29:23 PM)

I have the complete 60, including the manual, but I don't have a scanner. Still, I'll take a few high resolution photos of it and send them to you if you're ok with it



mike109 -> RE: OS Open rocker 60 parts and manual (5/2/2008 12:31:18 PM)

That would be wonderful Thank-you very much for the help. Michael you can send to my email address if you like. It is mike@leys.id.au Thanks again.



Page: [1]

Valid CSS!




SITE MAP!   : :   FORUM RULES

© 2001 - 2007 24-7 RC, LLC, all rights reserved.
0.09375