single speed conversion

single speed conversion (Full Version)

All Forums >> [RC Cars, Buggies, Trucks, Tanks and more] >> Exceed RC Support - Nitro Cars

Message

antjan514 -> single speed conversion (5/4/2008 4:52:57 AM)
Hey Andy.... Can you tell what parts I need to convert from 2 speed to single speed? And can I order it from Raidentech??? Thanks... Anthony

DonnyNitro -> RE: single speed conversion (5/4/2008 5:04:57 AM)
44t spur gear 5126 and Clutch bell 8011 should work well.

antjan514 -> RE: single speed conversion (5/4/2008 5:45:47 AM)
Thanks for the info... How will single speed compare to 2 speed as far as acceleration, and top speed?? Also can I use the same housing or do I need to order a different one?

DonnyNitro -> RE: single speed conversion (5/4/2008 3:16:59 PM)
http://www.youtube.com/watch?v=9h_a81f55z0 thats my Exceed 1/10 Nitro Extreme Forza with a single speed conversion on it. it is way fast. the tires break loose on accelleration on gravel and its fast bro. that is the whole gear set and brake unit. just take the 2 speed out and put that one in. you will be happy with it. i am.

antjan514 -> RE: single speed conversion (5/4/2008 4:54:40 PM)
Thanks much for the info ldgasp!!!! By the way, did you have to replace the clutch bell to the single gear or will the 2 gear clutch bell work??? Thanks... Anthony

DonnyNitro -> RE: single speed conversion (5/4/2008 7:48:36 PM)
use the 8011 clutch bell.

tihstae -> RE: single speed conversion (5/4/2008 9:00:32 PM)
ya i have the direct drive on my infinitive and i love it, good acceleration, better than stock, and loads of top speed.

antjan514 -> RE: single speed conversion (5/5/2008 4:33:46 AM)
OK guys... I think I'm going to be a "single speed convert". I am going to miss the way the buggy sounds when it shifts to 2nd. But eventhough I enjoy taking the buggy apart and putting her back together, doing so almost every time I take her out gets to be a little too much!!! Someone out there needs to come out with a much better 2 speed design. Until then.... single speed it is.... Thanks again guys... Anthony

Page: [1]

SITE MAP! : : FORUM RULES

© 2001 - 2007 24-7 RC, LLC, all rights reserved.

0.21875