Looking for dragsters or prostreet kit or parts? (Full Version)

All Forums >> [RC Cars, Buggies, Trucks, Tanks and more] >> RC Drag Racing



Message

misshydro -> Looking for dragsters or prostreet kit or parts? (5/6/2008 5:51:47 PM)

Hi,new to this area of drag racing r/c's. Wanted to know who's sells drag cars kits or part or cars. Want to get into r/c drag racing.



2916jr -> RE: Looking for dragsters or prostreet kit or parts? (5/6/2008 11:25:04 PM)

well there is a few
www.grandmotorsports.com
www.teamwalbern.com
www.rjspeed.com



misshydro -> RE: Looking for dragsters or prostreet kit or parts? (5/13/2008 3:08:50 AM)

Thanks! Has anyone seen or done putting a nitro motor inline of the rear axle? What I have a body and the motor got to sit in the center area of the body.



justinep -> RE: Looking for dragsters or prostreet kit or parts? (5/16/2008 12:22:51 AM)

I am a little confused... are you talking about a quickdrive tranny like some electrics have?



jpilkinton -> RE: Looking for dragsters or prostreet kit or parts? (5/18/2008 7:44:18 PM)


quote:

ORIGINAL: misshydro

Thanks! Has anyone seen or done putting a nitro motor inline of the rear axle? What I have a body and the motor got to sit in the center area of the body.


That is what I am working on. I am using a solid aluminum rod for the rear axle and making a hub to mount spur gear, and mounting the engine sideways.
I don't know how well it will do, but I will find out soon enough.



Brent Davis -> RE: Looking for dragsters or prostreet kit or parts? (5/18/2008 8:04:57 PM)


quote:

ORIGINAL: jpilkinton


quote:

ORIGINAL: misshydro

Thanks! Has anyone seen or done putting a nitro motor inline of the rear axle? What I have a body and the motor got to sit in the center area of the body.


That is what I am working on. I am using a solid aluminum rod for the rear axle and making a hub to mount spur gear, and mounting the engine sideways.
I don't know how well it will do, but I will find out soon enough.





You got any pics to post up yet?



jpilkinton -> RE: Looking for dragsters or prostreet kit or parts? (5/19/2008 1:31:11 AM)

quote:

ORIGINAL: Brent Davis


quote:

ORIGINAL: jpilkinton


quote:

ORIGINAL: misshydro

Thanks! Has anyone seen or done putting a nitro motor inline of the rear axle? What I have a body and the motor got to sit in the center area of the body.


That is what I am working on. I am using a solid aluminum rod for the rear axle and making a hub to mount spur gear, and mounting the engine sideways.
I don't know how well it will do, but I will find out soon enough.





You got any pics to post up yet?


Not at the moment. My machine will be here tuesday. I think on the chassis I will use two thin sheets of aluminum for the sides and make tiny mounts to bolt the sides together. I will post pics asap.



justinep -> RE: Looking for dragsters or prostreet kit or parts? (5/19/2008 1:44:52 AM)

Just so I am on the same page...

You are talking about a direct drive trans but, for nitro, correct?

Very cool idea! Post some pics or start a build thread!



Page: [1]

Valid CSS!




SITE MAP!   : :   FORUM RULES

© 2001 - 2007 24-7 RC, LLC, all rights reserved.
0.109375