Optic 6 page 22 sub manual (Full Version)

All Forums >> [Radios, Batteries, Clubhouse and more] >> RC Radios, Transmitters, Receivers, Servos, gyros >> Radio Manufacturer Direct Support >> Hitec/MultiPlex Radios- Ask Hitec Customer Service



Message

Blade47 -> Optic 6 page 22 sub manual (5/8/2008 3:12:10 PM)

I wanted to use elevators option ( option to use 2 servo's for the elevators ) and on page 22 of the sub manual it reads that you can use channels 1256 and as I have retracts on 5 I need to use 6 but that channel does not show so that I can slave to 2..... what am I missing?



Blade47 -> RE: Optic 6 page 22 sub manual (5/9/2008 4:06:54 PM)

[X(] OK have it now

Setting Up the Ailevator Function
1. This function requires two elevator servos, one for each side.
Plug the right elevator servo into channel 2, and the second
elevator servo into channel 5. If you need retracts, you will
have to use the output from channel 6.


I have to move the retracts onto channel 6 and use the slider for the switch then I can use 5 DOH!



Page: [1]

Valid CSS!




SITE MAP!   : :   FORUM RULES

© 2001 - 2007 24-7 RC, LLC, all rights reserved.
0.078125