Saito question? (Full Version)

All Forums >> [Glow Engines, Gas Engines, Fuel & Mfg Support Forums] >> Glow Engines



Message

rclement -> Saito question? (5/8/2008 9:03:00 PM)

How do you get pressure in the fuel tank if you are using a Saito flex exhaust? A couple of guys at the field have been trying to convert there exhausts to use these flex tubes but say they aren't getting enough flow from the fuel tank without a nipple and tube to pressurize the tank.



Ernie Misner -> RE: Saito question? (5/8/2008 9:21:24 PM)

You install your own pressure fitting up near the header somewhere, where there is enough meat to drill and install it. It works great if you use a 90 degree alum. adaptor that you can drill into for sure.

Ernie



w8ye -> RE: Saito question? (5/8/2008 10:43:23 PM)

Some of the flex pipe come from Saito with a pressure nipple



rclement -> RE: Saito question? (5/9/2008 4:59:58 PM)

Thanks guys. Yeah, one that I've seen has the 90 degree adapter so he was planning to drill it and put a nipple on it.



Page: [1]

Valid CSS!




SITE MAP!   : :   FORUM RULES

© 2001 - 2007 24-7 RC, LLC, all rights reserved.
0.046875