|
UTM -> RE: How is suppose to hover blade CX2??? (5/9/2008 4:14:34 AM)
|
Carlos - My CX2 has always behaved predictably in that during the flight as the battery discharges it will begin to rotate one way or the other. It has always been nose left for mine. I will start with the rudder tab dead center and by the end of the pack I will be about 3 clicks left on the tab. the motors although pretty well made still are not precision engeneered. The will have slightly different resistance rates and this is what causes the rotation. As the pack gets lower it amplifies the problem. it is perfectly normal. As far as the hover behavior goes you should be able to dial in a stock CX2 to hover on 1 spot for a number of seconds without any inputs. it is sometimes called hands-off hover. 10 seconds or around about is not abnormal for a well tuned bird. Now of course if you start putting mods on it to make it more agile you will sacrifice stability and that window will shrink. I have alum upper, lower, bearing cup, swash plate. Xtreme 180bb motors v1, a CF boom, and a shortened flybar. my CX2 will still hover very stable but not hands off for long. I still have no problems keeping it inside a 2' area with no toilet bowel swirl. Keep at it. You'll get there. the soloboss guide that arrow posted will help alot. Read it, live it. Everything will apply to your bird as everything on the CX2 is the same as the CX besides the radio equipment and the airframe.
Good luck and don't be discoraged.[:D]
|
|
|
|
