What does the rear servo connect to on the belt CP? (Full Version)

All Forums >> [RC Helicopters] >> Electric RC Helis >> Esky Helicopters



Message

Husko -> What does the rear servo connect to on the belt CP? (5/10/2008 2:59:02 AM)

Just taking another look at pitcures for the belt CP. Is the belt inside the tail boom, and what does the servo and the push rod going to the tail do?

Thanks!



noobflyer01 -> RE: What does the rear servo connect to on the belt CP? (5/10/2008 3:03:59 AM)

yes. the belt is inside the boom. the rod and servo works together to move the tail pitch slider that controls the pitch of the tail rotors. these parts work with the gyro (when its working properly) to stop the tail from spinning with the torque of the main rotors. basically tail control. essential.



Zimatosa -> RE: What does the rear servo connect to on the belt CP? (5/10/2008 7:52:02 AM)


quote:

ORIGINAL: Husko

Just taking another look at pitcures for the belt CP. Is the belt inside the tail boom, and what does the servo and the push rod going to the tail do?

Thanks!


Make sure that you put many hours into that flight sim before flying the CP..Hehehe I had about 60 hours on my sim before I bought and flew a real one. The more orientation memory you build, the less it will cost to fly the Belt. RC Heli's are much more expensive to fix when crashed!....Wait, is HBK2 real? [;)]


Z



Page: [1]

Valid CSS!




SITE MAP!   : :   FORUM RULES

© 2001 - 2007 24-7 RC, LLC, all rights reserved.
0.078125