Custom Exhaust Question (Full Version)

All Forums >> [RC Cars, Buggies, Trucks, Tanks and more] >> [RC Car Engines] >> Car Nitro & Gas Engines



Message

907STROKER -> Custom Exhaust Question (5/10/2008 10:25:14 PM)

I am thinking of doing the front engine mod to my X-Factor 2 and was wondering if it would be bad for the engine (performance wise or just plain bad for it) to make a custom exhaust system out of Stainless Steel Tubing. Has anyone already done this, if so, pics would be great. Thanks



savagecommander -> RE: Custom Exhaust Question (5/10/2008 11:58:04 PM)

if you can weld look up tuned pipe designer, a java program that does the math for you. it gives you demensions and then you do the rest. pretty neat actually.



907STROKER -> RE: Custom Exhaust Question (5/11/2008 12:07:48 AM)

Thanks for the info. I have access to a wire feed, but I'll have to look into welding SS. I know a couple welders that could handle this project, all I need to do is design the pipes. Thanks again.



907STROKER -> RE: Custom Exhaust Question (5/11/2008 12:25:00 AM)

OK, I took a look at the websites, I found a couple different ones. That is way more complicated than the idea I had. I just wanted to run a couple lengths of SS Tubing down each side and make some cool looking dual pipes, but it looks as thoughit is not that easy. Now I gotta try and figure something different out.



Page: [1]

Valid CSS!




SITE MAP!   : :   FORUM RULES

© 2001 - 2007 24-7 RC, LLC, all rights reserved.
0.078125