|
dabigboy -> Battery question (5/11/2008 5:58:44 AM)
|
I have a 1200ma li-po I bought last year with a Walkera 22A. It was left without charging or anything for quite a few months (I know, bad me), I just got an Axe CP (which is WORLDS better than the Walkera!!!!) and now I want to use the li-po in it as the stock batteries are woefully weak. So I hooked it up to my balancer/charger thing just now and noticed on the LCD panel, only 2 cells showed up as charging. The third didn't respond, like it was a 2 cell pack. I went ahead and let it charge. The other two cells seemed to charge fine but I never saw any data displayed for #3. I now have a little under 10 volts showing with no load. Is there anything I can do for this pack, or is it toast? On a semi-related note, I just put in 2 quick "flights" on the Axe in my living room, and actually had a decent hover going several times on the second flight.....annnnd now I am HOOKED! :p Can't wait to get it outside or somewhere else where I have room to move around!
|
|
|
|