Kyosho Sandmaster (Full Version)

All Forums >> [RC Cars, Buggies, Trucks, Tanks and more] >> [RC Car Engines] >> Car Nitro & Gas Engines



Message

muz14 -> Kyosho Sandmaster (5/11/2008 9:45:07 AM)

I am on a mission to rebuild and revive the old Nitro buggy Kyosho Sandmaster. Any help with this would be great.

http://kyoshosandmaster.blogspot.com/



muz14 -> RE: Kyosho Sandmaster (5/15/2008 8:07:54 PM)

Anyone no where I can source body shells for a Kyosho Sandmaster.

http://kyoshosandmaster.blogspot.com/



UG0TB4NN3D -> RE: Kyosho Sandmaster (5/15/2008 8:44:42 PM)

I believe this would be where you could find one.

http://www.udisco.com/hobbies/inv/KYOS08.HTM

Search for body, I believe it's SM16.



The_Collector -> RE: Kyosho Sandmaster (5/16/2008 3:17:17 AM)

Anything you need to know, just ask. I've had/ have more of these than any one person should.
They're so simple and fun, I just can't seem to keep them away.



muz14 -> RE: Kyosho Sandmaster (6/12/2008 8:07:37 PM)

That's great to know, Do you know if you can use different sizes of gear spur?



The_Collector -> RE: Kyosho Sandmaster (6/13/2008 4:08:00 AM)

I have only used the two made by Kyosho. With the ST and MK Sandmasters, it was the standard gear with no slipper clutch. With the Tracker and RAV4(Sandmaster variants) models, they used a gear with a few more teeth, and the center is a bit different to accomidate the slipper. To change gearing, you change the clutch bell.



Page: [1]

Valid CSS!




SITE MAP!   : :   FORUM RULES

© 2001 - 2007 24-7 RC, LLC, all rights reserved.
0.109375