PZIV Drive Sprocket (Full Version)

All Forums >> [RC Cars, Buggies, Trucks, Tanks and more] >> RC Tanks



Message

Deano1661 -> PZIV Drive Sprocket (5/11/2008 10:33:06 AM)

Hi guys, pretty new to this hobby, how would I correct the drive sprocket location on my h/l PZIV, how do i do it and what parts would i need?

Deano



blitzkrieg65 -> RE: PZIV Drive Sprocket (5/11/2008 3:16:45 PM)

What do you want to do, bring it in, pull it out some, do you want to lower it or raise it up,?


The Blitz



Deano1661 -> RE: PZIV Drive Sprocket (5/11/2008 8:28:06 PM)

The sprocket looks like it needs to go back and up by about 8 mm, would i need the low profile stug 3 gearboxes or can the standard ones be made to fit, there doesn't seem to be enough room to move them, how have you guys done it

Deano



Red_Rabbit -> RE: PZIV Drive Sprocket (5/12/2008 6:40:33 AM)

Hi Deano

Easiest way (inexpensive) might be to tilt those gearboxes backwards. That way the front will go higher and little bit back also.

I havent done that yet by myself, but have measured that it could be done. If I remember right, correction with those Stug-gearboxes has been done with success.

Yours,

Red Rabbit




Page: [1]

Valid CSS!




SITE MAP!   : :   FORUM RULES

© 2001 - 2007 24-7 RC, LLC, all rights reserved.
0.0625