brake cam (Full Version)

All Forums >> [RC Cars, Buggies, Trucks, Tanks and more] >> Exceed RC Support - Nitro Cars



Message

cirec -> brake cam (5/11/2008 8:30:50 PM)

I was moving the brake cam back and forth and it fell out.I can't get it back in.I can't take the brakes off because I don't know what tool i'm suppost to use.I thought I'm suppost to use an allen wrench but it dosen't work.How do I get the brake cam back in?



yadac123 -> RE: brake cam (5/12/2008 1:46:13 AM)

You need to remove the entire gear unit out from the car. There is a little tiny metal that locks the cam in place.

Andy



AllAboutFunHobbies -> RE: brake cam (5/13/2008 2:09:19 PM)

You need to remove the entire transmission, once you remove the entire transmission you need to take the brake pades and disk off and behond the back set of pads is a whole there should be a small hardened steel piece of metal, almost like a cylinder shape that goes in the hole, if you have it place it back in the whole and repeate the whole process backwards to put it back together.



yadac123 -> RE: brake cam (5/13/2008 10:20:51 PM)

do you still have that tiny metal piece?

Andy



cirec -> RE: brake cam (5/14/2008 9:50:53 PM)

What tool do I have to use to get the brake pads off?



yadac123 -> RE: brake cam (5/14/2008 10:29:57 PM)

you'll need a 2.5mm Hex screw driver.

Andy



cirec -> RE: brake cam (5/26/2008 5:00:29 AM)

The cylinder piece of metal was already in.Do I have to take it out?



Page: [1]

Valid CSS!




SITE MAP!   : :   FORUM RULES

© 2001 - 2007 24-7 RC, LLC, all rights reserved.
0.125