A new body for a Thunder Tiger ST-1 (Full Version)

All Forums >> [RC Cars, Buggies, Trucks, Tanks and more] >> RC Truggy



Message

XAVIERZX11 -> A new body for a Thunder Tiger ST-1 (5/12/2008 5:10:51 PM)

My TT will be here TODAY!!!:-) What body will fit the ST-1? I want one with a wing or one I can put a wing on. Thanks

Paul



kweezinarts -> RE: A new body for a Thunder Tiger ST-1 (5/12/2008 5:51:08 PM)

not sure about the body, just dont use thunder tigers manual for break-in procedure. use one of the many heat cycle methods found in the forums as a guideline...



HerrSavage -> RE: A new body for a Thunder Tiger ST-1 (5/12/2008 7:09:09 PM)

I'm pretty sure the Proline Crowd Pleazer 2.0 for Mugen MBX5T fits.. - the best looking CP2.0 anyway IMO...

Then there's the new Reckward Tuning Symbio body.. Some like 'em, some don't.. I do.. Look up "symbio" at www.amainhobbies.com .... (The paint schemes they're advertised with at Amain are kinda' retarded, but the bods are cool..)



XAVIERZX11 -> RE: A new body for a Thunder Tiger ST-1 (5/15/2008 4:42:42 AM)

Thanks.
Will a proline wing fit on the TT ST-1 body? Oh by the way I broke-in the engine using the heat cycle way. I will never use the old way again. Thanks again.



Paul



madmax22 -> RE: A new body for a Thunder Tiger ST-1 (5/16/2008 1:04:52 AM)

a wing doesnt go on the body... a wing goes on a wing mount (seperate from the body) but if you get a wing mount any 1/8 buggy/truggy wing will fit... The crowd pleaser 2.0 for the MBX fits..



redfox03 -> RE: A new body for a Thunder Tiger ST-1 (5/16/2008 4:04:18 AM)

check out the pics in my gallery of my st-1. the rear body body mount is actually a wing mount. you can get some extra body mount posts and put them on the rear shock tower so you can use the wing mount that's already on there. the crowd pleazer body for the mugen fits, and so does the jconcepts illuzion body for the kyosho st-r. i have the illuzion body.


edit:
whoops, the pics of my st-1 aren't in my gallery. i'll find em. oh yeah, you can also get the extended wing mount too.



chedster -> RE: A new body for a Thunder Tiger ST-1 (5/16/2008 4:17:44 AM)

PL mugen body works nicely and also the Jconcepts MGT body. Fits almost perfect IMO. Here is a shot of the MGT body



Page: [1]

Valid CSS!




SITE MAP!   : :   FORUM RULES

© 2001 - 2007 24-7 RC, LLC, all rights reserved.
0.078125