Help with Aftershock? (Full Version)

All Forums >> [RC Cars, Buggies, Trucks, Tanks and more] >> RC Monster Trucks >> Losi Monster Trucks



Message

polaris472 -> Help with Aftershock? (5/13/2008 3:22:44 PM)

Here is the problem that happened last night when I was running my Aftershock.
I was running it and happened to drive back to where I was and noticed I only have front wheel drive now.
I can spin the rear wheels and it will spin the drive shaft, but no power from the transmission ( I don't think).
Any idea on what could be the problem, it ran fine for 30 minutes before this happened.



RCtruckRacer -> RE: Help with Aftershock? (5/13/2008 3:51:57 PM)

Most likely the set screw on the outdrive from the tranny to the driveshaft has come loose. Make sure it is on the flat spot when you tighten it, and blue loctite there will help keep it in place.



polaris472 -> RE: Help with Aftershock? (5/13/2008 4:13:15 PM)

I did look at that and it is still tight. I will look at it again and make sure it is on the flat
spot.



RCtruckRacer -> RE: Help with Aftershock? (5/13/2008 8:16:12 PM)

It could also be the set screw on the outdrive of the diff.



polaris472 -> RE: Help with Aftershock? (5/13/2008 8:18:59 PM)

I will look at that as well this evening and hopefully that will fix it. If not I will report back.
Thanks



jbb -> RE: Help with Aftershock? (5/14/2008 12:28:58 AM)

the grub screws on the cvds check them



Grits -> RE: Help with Aftershock? (5/14/2008 1:47:52 AM)

The grub screws on the front and back side of the tranny should line up with each other, one way to tell if one of the screws loosened and let the cup spin.



bjhe333 -> RE: Help with Aftershock? (5/14/2008 2:30:33 PM)

Check the wheel nuts and the inside of the rim to make sure the hexes aren't rounded off



polaris472 -> RE: Help with Aftershock? (5/16/2008 3:52:16 PM)

Thanks for your help guys. I got her up and going again and ready to bash some more tonight.
It was one of the screws had came loose.



Page: [1]

Valid CSS!




SITE MAP!   : :   FORUM RULES

© 2001 - 2007 24-7 RC, LLC, all rights reserved.
0.265625