Swapping Futaba FASST RXs (Full Version)

All Forums >> [RC Airplanes] >> Questions and Answers



Message

Wblakeney -> Swapping Futaba FASST RXs (5/16/2008 12:47:48 AM)

I am just curious what experience people have with changing FASST receivers with a transmitter. Anyone ever see any noticeable difference, e.g. trim, servo travel when you replace one receiver with another. I have 3 607s and 1 707 receiver and two 6 ch. transmitters and may have use all of them with the same transmitter or move them back and forth.



draftman1 -> RE: Swapping Futaba FASST RXs (5/16/2008 6:35:42 AM)

everything has worked just like it is suposed to. no noteciable differences



pt19 flyer -> RE: Swapping Futaba FASST RXs (5/24/2008 5:55:46 PM)

hi

all programming data is stored in the TX. so changing to another receiver requires no changes. just link to TX and all will be ok!

good luch and happy flying

pt19 flyer



Wblakeney -> RE: Swapping Futaba FASST RXs (5/25/2008 12:15:46 AM)

I know the programming is stored in the Tx, just curious how matched the receivers were. I have two 6 ch Tx and 3 606 RX and 1 607 Rx. As I swap RXs back and forth between plans, I did not want to make sure I always got the same RX back in the plane.



draftman1 -> RE: Swapping Futaba FASST RXs (5/25/2008 6:42:36 AM)

I swap all the time, no problems at all, I have a mix of the recievers also, its great just to push the button to bind, very cool



Page: [1]

Valid CSS!




SITE MAP!   : :   FORUM RULES

© 2001 - 2007 24-7 RC, LLC, all rights reserved.
0.15625