Need digital servos and RX help

Need digital servos and RX help (Full Version)

All Forums >> [RC Helicopters] >> Electric RC Helis >> Esky Helicopters

Message

carpez -> Need digital servos and RX help (5/17/2008 7:02:28 AM)
I fly a HBK2 and I have just purchased a Spektrum DX7. I am using a ALIGN RCE 500x GYro. Will I need to buy another Gyro? and what digital servos and RX should I purchase to work with the HBK2 and DX7. Any help would be greatly appreciated. PEZ

funflier -> RE: Need digital servos and RX help (5/17/2008 10:34:17 AM)
That is a rebadged telebee gyro and its not digtal (it cant talk to a digital servo) so its a total waste to put a digital servo (50$- 100$ servos) on it, which is good unless your into heavy 3d flying which your probably not. Its a good gyro for the price and works well with a futaba 3114 analog servo for the tail (3114 is very strong and fairly fast for the 15$ price). I run one on my King and have no issues or problems with it

carpez -> RE: Need digital servos and RX help (5/20/2008 7:57:02 AM)
Hi Funflyer welome from down under . The problem is I own a DX7 and fly a Hurricane 550. What I would like to do is fly the Honey Bee King 2 with the DX7 also. Now to do so what gear would I have to buy. 1 What model and make [8\|]of digital servo 2 What model and make of Gyro 3 What make of servos to suit the Honey Bee king and the DX7 Mate if you could give me some ideas I would greatly appreciate it. Thanks Pez

Druss -> RE: Need digital servos and RX help (5/20/2008 5:16:01 PM)
carpez, you realize that you don't need to change anything beyond the receiver? I'd suggest the 6200 for the receiver as it's cheaper than the ar7000.

funflier -> RE: Need digital servos and RX help (5/20/2008 9:58:35 PM)
I would put in e AR6100e rx as its smaller then the stock or the 6200 works with the dx7, is in one piece, best of all it's low cost [:D] (US$50) check out ebay for world wide and you have several people in your area selling them. While your at it put on a Telebee HH gyro ($US40) and a Futaba S3114 tail servo ($US15) Its a strong fast servo and is analog, replace the servo arm with a Hitec HS55 one (thicker and wider) and your all set. Oh and upgrade the motor and ESC before they fail or burn.

Page: [1]

SITE MAP! : : FORUM RULES

© 2001 - 2007 24-7 RC, LLC, all rights reserved.

0.09375