why wont it work??? (Full Version)

All Forums >> [RC Helicopters] >> Electric RC Helis



Message

savagegti -> why wont it work??? (5/24/2003 7:42:49 PM)

:mad: I have just put seperates on my hb/df ive followed hellihobby instructions.
but when i went to power up i got nothing then the motors started spinning on their own i had no control
servos are gliching nothing is working
im using csm gyro hlg 200,6channel rx,cheap gws tx 4 channel,and gws ecs,s
could it be tx rx problem,ive checked wiring
any ideas anyone? :confused:



Bacon2002 -> why wont it work??? (5/24/2003 8:16:57 PM)

Hi,

I don't know that much about R/C stuff myself but it does sound like the receiver isn't getting the signals.

I'd check the transmitter is in the correct mode PPM/PCM and that the crystals in both the transmitter and receiver are correct.

David



savagegti -> why wont it work??? (5/24/2003 8:58:59 PM)

just tried different tx
works beautifull
cheers



Page: [1]

Valid CSS!




SITE MAP!   : :   FORUM RULES

© 2001 - 2007 24-7 RC, LLC, all rights reserved.
0.046875