t6exhp dual aileron servos (Full Version)

All Forums >> [Radios, Batteries, Clubhouse and more] >> RC Radios, Transmitters, Receivers, Servos, gyros

Message

---

bryon -> t6exhp dual aileron servos (4/5/2009 2:04 AM) I got a used futaba t6exhp radio got the manual too can u set up a plane with dual aileron servos without a y-harness i cant figure it out the programing if you can thanks Bryon

---

BuschBarber -> RE: t6exhp dual aileron servos (4/5/2009 7:16 AM) I am not familiar with that radio. Generally, if it is a computer radio, you would use the Flapperon program to mix channels 1 and 6. If it is not a computer radio then I know Futaba makes a device like the JR Matchbox that you would connect to the Aileron channel and then connect both Aileron servos to the Matchbox. It allows you to connect up to 4 servos to one channel and Match them for Neutral, End Points, and Servo Direction. It is much more reliable than a Y harness and much more versatile.

---

bryon -> RE: t6exhp dual aileron servos (4/5/2009 8:18 AM) Dumb me i goofed i was trying to use ch 1 and 5 it works thanks BuschBarber [:D] Bryon

---

Kody the Bear -> RE: t6exhp dual aileron servos (6/28/2009 4:13 PM) Hello, guys... I'm new to the programmable radios and I need some direction, please. My manual isn't very helpful, so I thought I'd try the "go to" guys. I have a Spektrum 7chnl and I would like to program Flaporons using 2 airlon servos. The radio came with a AR6100 6chnl rec'vr. I have seen some articles on using the Aux-2 chnl for this, but my rec'vr is 6 chnl with only one aile port :-( My question is: can I use chnl 5 [[gear] to install one of the aile sx and program it to use the flaporon function? Thx for your input. Kody

---

Page: [1] 1

SITE MAP!   : :   FORUM RULES RC Universe is a service of Internet Brands, Inc. Copyright © 2001-2013.

0.1542969