Use of Allen Cap Head Bolts vs Phillips Head for Servo Arm (Full Version)

All Forums >> [Radios, Batteries, Clubhouse and more] >> RC Radios, Transmitters, Receivers, Servos, gyros >> Radio Manufacturer Direct Support >> Hitec/MultiPlex Radios- Ask Hitec Customer Service



Message

dblades -> Use of Allen Cap Head Bolts vs Phillips Head for Servo Arm (6/17/2003 11:13:25 PM)

Have 5645 and 5945 servos and would perfer to use Allen Cap Head vs Phillips Head bolts for Servo Arms. Any problem and if not what size? Thanks in advance.



MikeMayberry -> Use of Allen Cap Head Bolts vs Phillips Head for Servo Arm (6/18/2003 12:43:53 AM)

You will probably have a hard time finding any. They are 2.6mm.



dblades -> Use of Allen Cap Head Bolts vs Phillips Head for Servo Arm (6/18/2003 12:52:56 AM)

Thanks Mike.

FYI - I went to Micro Fastners web site and they have a M2.6 X 8 part number SCM2608. I think that will work.

Thanks again,
Dennis



SilverEagle2 -> 2.6mm by... (6/18/2003 12:55:37 AM)

They are 2.6mm X 8mm right.

[URL=http://www.mcmaster.com/param/asp/psearch.asp?FAM=scs&FT_110=284&FT_210=50897&FT_255=45178&FT_136=40154&session=scs;110=284;210=50897;255=45178;136=40154]McMasters[/URL] has them for $10 for 50.

Jason



Page: [1]

Valid CSS!




SITE MAP!   : :   FORUM RULES

© 2001 - 2007 24-7 RC, LLC, all rights reserved.
0.109375