quote:

ORIGINAL: fmattox11

Order # yhst17210252890263-87863 (taken from your post)

Seawind ARF

On Page 7 of the manual, there is a picture of the water rudder on the bottom of the fuselage. Just above it is a picture of the water rudder control rod and set screw and then to the left it shows the fitting that the control rod fits into in order to allow the control rod to
move the water rudder with the flying rudder. I would need all three pieces of the assembly.

On Page 2 of the manual, there is a picture of the hatch cover that appears to be taped across the hatch that you would normally place the fuel tank and motor servo inside of. I was missing the hatch cover. (and any hardware to hold it down with if any was supplied)

Thanks

Frank Mattox
Goodyear, Az.

quote:

ORIGINAL: av8tor1977

Hi,

Some time ago, I bought the Mustang shown below from you at NitroPlanes. I finally got it out today to start building it, and I see there are no instructions. Can you please provide me with the instructions/manual for this airplane?

Also, do you have any word on when you might get the CMP Christen Eagle or similar back in stock??

Thanks,
AV8TOR
Sorry for the multiple post, I believe this is the correct spot for this post... Hadn't had my morning coffee yet; brain fade.

quote:

ORIGINAL: trikebldr

OK, I've tried the Nitroplanes live chat, email and phone calls to customer servece, but have been shined on, put on hold for way too long and just plain ignored and lied to. I bought my 91'' span Piper Cub over a month and a half ago, and immediately noticed that it came with the manual for the wrong model. I called the customer service line and was told that a new manual would be sent out. Never got it! Over a week ago I emailed them and received a rply that someone would contact me within two business days. It's been over seven business days, now, with no contact. I emailed them again yesterday with the same reply, but no contact, yet. I tried the live chat today, and was left hanging after the initial greeting from Sam for over ten minutes before I gave up. I called and was put on hold for more than ten minutes after beginning to work with a real person. All I want is the correct manual for this model, as well as the missing small decal sheet for the tail, and one of the two longer control rods for the elevators. I am sure of these missing parts just from looking at the online pics of what comes in the box. Who knows? Maybe there are more missing parts, but I can't tell, because I didn't get a correct manual for this model to refer to the parts list. 

I would send this model back for a refund out of frustration and disgust, but I'm afraid I would never see a refund of my money if I did, so I will just make the best of what I have on hand and be sure to tell all of my flying buddies about my bad experience with this company's customer support. If this sounds a bit harsh, it's nothing compared to how I feel about how I've been treated in this purchase.

quote:

ORIGINAL: JGruener

Hi john,
My Order Id is 660616
I have got the bf109, Durring inspection I found the sheeting on the left wing to be cracked perrty bad. Also one the the ribs split. And the gear housings are all cracked up. There are a few splits and cracks in the paint in the fuse, but I don't think that it has any major damage. I thin the box was steped on. box looked banged up.
Thanks let me know
Jason

quote:

ORIGINAL: JGruener

Yes it is the left wing from the pilots veiw point. are you going to ship one to me? Do you have all of the information that you need?
THanks
yhst-17210252890263-98876
Jason Gruener

quote:

ORIGINAL: scooty

Hello John,

Order # yhst-17210252890263-99075

http://www.nitroplanes.com/newaryeulbi4.html

I just got the new Yellow and White Ultimate 40 ARF, (Excellent little airplane btw) and am missing the following pieces;

2 of the ''aluminum screws,'' shown on pg 5, step 4 of the manual.

These have a eyelet on one end for a bolt to pass through, and screw threads on the other end. They're used to attach the inter-plane struts to the wings.

Could you please ship the missing parts to me?

quote:

ORIGINAL: JGruener

Thanks John,
Hey I got a billing via email though nitro planes for the amount of 300.00. Is this just a copy of the orginal purchase. Or am I being billed again?
Thanks
Jason

quote:

ORIGINAL: bryant50

i just recently got my cmp hellcat. it came damaged there was no damage to the shipping box are the box it self i sent pics of everything to customersupport@nitroplanes with no response... Whats a guy yo do

Here are some pictures of the damage to the left wing (from pilot's seat), fuse, and elevator.
My order number is YHST-17210252890263-98464.
Here is a link to the kit I ordered: http://www.nitroplanes.com/hellcat120.html