|
matadco -> fillings (8/1/2009 5:50 PM)
|
I tried filling some cracks using 20 minute Finish-Cure and microballons filler. I mixed the Finish-Cure at 1 to 1 and added the Microbaloons to a creamy past. It never cured. Trying to sand and it was a rubbery goo. This was after over 1 hour then again at two hours and finally over night. No difference. The mess never cured where I could sand it. Now, the Finish-Cure may have been a little old as it had sat about 1 year in the shop but the interior pugs were replaced and the the caps screwed on tight. The Microballoons was just purchased for this project. I mixed the epoxy well before adding the microballoons. The last time I used the Epoxy was on fiber glass tape on wing center and there was no problem with it curing. What did I do wrong?
|
|
|
|
