CLD Anarchy Airboat    Gallery
View related threads: (in this forum | in all forums)

Tower Hobbies
Enter up to 4 keywords or Tower stock numbers
Logged in as Guest



Users viewing this topic: sgtcuts, RS 38-40
    Search This Thread  
 
Printable Version

All Forums >> RC Boats >> RC Airboats >> CLD Anarchy Airboat
Page: [1]

Login
Message << Older Topic   Newer Topic >>
CLD Anarchy Airboat - 2/8/2010 9:02 PM   
2manytoyz



Posts: 141
Score: 100
Joined: 8/22/2005
Last Login: 8/9/2010
From: Cocoa, FL, USA
Status: offline 		I guess I'm one of the first ones lucky enough to get one of these new airboats from Carlos at C Laser Designs. This model is the Anarchy, intended for a brushless motor, but he has a nitro version as well.

The kit is very reasonably priced, and FAR better quality than anything Dumas ever produced. The parts are laser cut, making all the parts precise, and the joints tight. For $50 more, I had Carlos build, seal, and mount the electronics. Worth every penny, he did a nice job. It arrived well packaged, and I quickly got to installing the radio receiver & servo. I drilled holes in the deck for the hatch latches, and a hole in the hatch for the antenna tube.

I took it out while on an errand for a quick test on the pond. Holy Poop Batman, the power to weight ratio is AWESOME! I had it airborne a couple of times with a little too much throttle. It easily climbs to the top of the steep bank, something my nitro powered airboat can't do.

I've never owned a brushless motor or LiPo batteries before. I knew these motors had a fair amount of power, but WOW. I would have thought an electric airboat to be fairly quiet, but it spins the prop so hard, it makes quite a roar. Not as loud as the nitro models, but you won't be sneaking up on a duck anytime soon either.

I ran it hard for about 10 minutes before the pack died. Very little warning, just suddenly fell off plane, and settled into the water. Done. I managed to get a few throttle burps to bump it back to the nearest bank. Excellent performance right up to the end, no complaints.

Following Carlos' advice, I put the battery pack in the center of the hull, and as far back as it would slide. The balance is very good, and drifts nicely in the turns. But this is a small boat, prone to weathervaning in cross winds. I might add a small piece of 1/8"x1/8" down the center of the hull to help with stability at high speeds.

So far, nothing but grins. Performance is excellent, handling is pretty good and expect a slight tweak to improve that a bit too. Very good design. I might mothball the Dumas Windy I was building. Just no comparison when it comes to quality of materials in the two kits.

There will be videos and I'll take pics with the big Nikon later (I'll get Dennis to drive while I shoot, or vice-versa). Sorry for the quality of these shots, hard to drive and shoot with a cheapie camera at the same time...



Attachments
Click to see fullsize image.
Click for fullsize 		Click to see fullsize image.
Click for fullsize 		Click to see fullsize image.
Click for fullsize 		Click to see fullsize image.
Click for fullsize
Click to see fullsize image.
Click for fullsize 		Click to see fullsize image.
Click for fullsize 		Click to see fullsize image.
Click for fullsize 		Click to see fullsize image.
Click for fullsize
Click to see fullsize image.
Click for fullsize 		Click to see fullsize image.
Click for fullsize 		Click to see fullsize image.
Click for fullsize 		Click to see fullsize image.
Click for fullsize


Hide Signatures
       Post #: 1

RE: CLD Anarchy Airboat - 2/8/2010 9:04 PM   
2manytoyz



Posts: 141
Score: 100
Joined: 8/22/2005
Last Login: 8/9/2010
From: Cocoa, FL, USA
Status: offline 		More pics



Attachments
Click to see fullsize image.
Click for fullsize 		Click to see fullsize image.
Click for fullsize 		Click to see fullsize image.
Click for fullsize 		Click to see fullsize image.
Click for fullsize
Click to see fullsize image.
Click for fullsize 		Click to see fullsize image.
Click for fullsize


Hide Signatures

(in reply to 2manytoyz)
       Post #: 2

RE: CLD Anarchy Airboat - 2/9/2010 1:47 AM   
claserdesigns



Posts: 207
Score: 100
Joined: 8/27/2009
Last Login: 8/26/2010
From: Clermont, FL, USA
Status: offline 		That's a nice airboat you got there , you don't mind if I steal those pictures for my website do you?

You were the second person who ordered one from me and the only one who got it already built, I hope you like it, I shipped several of this airboats this past weeks so I hope to see them soon built and running. I'm working on the gas version this week, same design just much bigger and hopefully we can meet someday to do some friendly racing

PS: I can't wait to see videos





_____________________________

Owner of C Laser Designs
R/C Laser Cut kits and Parts

Hide Signatures

(in reply to 2manytoyz)
       Post #: 3

RE: CLD Anarchy Airboat - 2/9/2010 2:07 PM   
2manytoyz



Posts: 141
Score: 100
Joined: 8/22/2005
Last Login: 8/9/2010
From: Cocoa, FL, USA
Status: offline 		Help yourself to the pictures. Hopefully I'll get better action shots with the Nikon D70s later.

Looking forward to the 26cc gasser version. I'll "need" one of those too! Maybe you should send me your prototype for photographic documentation...

Me -n- Dennis are in the Cocoa area, tad over an hour East of you. You're welcome to come run with us anytime. Dennis periodically makes the trip up to Ocala once a month. I've been there once, hope to go again soon.

I might end up ordering a second kit just to have a spare. Really impressed with it!

Hide Signatures

(in reply to claserdesigns)
       Post #: 4

RE: CLD Anarchy Airboat - 2/9/2010 2:45 PM   
claserdesigns



Posts: 207
Score: 100
Joined: 8/27/2009
Last Login: 8/26/2010
From: Clermont, FL, USA
Status: offline 		I got married on Satellite Beach, I love that area over there. As soon I finish the gas version we can plan a "playdate" hehe.

_____________________________

Owner of C Laser Designs
R/C Laser Cut kits and Parts

Hide Signatures

(in reply to 2manytoyz)
       Post #: 5

RE: CLD Anarchy Airboat - 2/10/2010 11:21 PM   
2manytoyz



Posts: 141
Score: 100
Joined: 8/22/2005
Last Login: 8/9/2010
From: Cocoa, FL, USA
Status: offline 		Small world. I lived in South Housing (PAFB) in Satellite Beach for a year.

Hide Signatures

(in reply to claserdesigns)
       Post #: 6

RE: CLD Anarchy Airboat - 3/11/2010 2:45 PM   
claserdesigns



Posts: 207
Score: 100
Joined: 8/27/2009
Last Login: 8/26/2010
From: Clermont, FL, USA
Status: offline 		Thanks for the pics and videos, they are now uploaded on my site.

_____________________________

Owner of C Laser Designs
R/C Laser Cut kits and Parts

Hide Signatures

(in reply to 2manytoyz)
       Post #: 7

RE: CLD Anarchy Airboat - 3/14/2010 3:47 AM   
2manytoyz



Posts: 141
Score: 100
Joined: 8/22/2005
Last Login: 8/9/2010
From: Cocoa, FL, USA
Status: offline 		Hopefully have more pictures & videos next weekend. Been busy with home remodeling stuff...

Your website is looking good! But it's 2manytoyZ, not 2manytoys. When I went to register my website, someone already had that domain name Oh well.

A little fine tuning, might have some of the gasser boys worrying.

One thing I love about this FAST boat, is that it's quiet enough to run on the neighborhood pond, without some blue haired old bitty fussing about the noise.

Hide Signatures

(in reply to claserdesigns)
       Post #: 8

RE: CLD Anarchy Airboat - 7/29/2010 10:04 PM   
claserdesigns



Posts: 207
Score: 100
Joined: 8/27/2009
Last Login: 8/26/2010
From: Clermont, FL, USA
Status: offline 		I made a little video with action shots, thanks 2manytoyz for the videos and pics.



_____________________________

Owner of C Laser Designs
R/C Laser Cut kits and Parts

Hide Signatures

(in reply to 2manytoyz)
       Post #: 9

RE: CLD Anarchy Airboat - 9/9/2010 8:17 AM   
sgtcuts


 

Posts: 1
Score: 100
Joined: 5/28/2010
Last Login: 6/4/2010
From: , FL, USA
Status: online
quote:

ORIGINAL: claserdesigns

I made a little video with action shots, thanks 2manytoyz for the videos and pics.




Hey Carlos I have tried to contact you every way i can you still owe me a boat please email me asap i am sending you a pm with my email address



Hide Signatures

(in reply to claserdesigns)
       Post #: 10

Page:   [1]
All Forums >> RC Boats >> RC Airboats >> CLD Anarchy Airboat
Page: [1]





Jump to:


 
Google 



Search | Marketplace | Event Calendar | Local Clubs | Magazine | Product Ratings | New Products | Discussion Forums

Photo Gallery | Instructor Search | Field|Track|Marina Search

Advertisers | Hobby Vendor Resources | Rate Manufacturers | Sign In/Sign Up

SITE MAP!   : :   FORUM RULES

© 2001 - 2007 24-7 RC, LLC, all rights reserved.

Charities we support that also need your help
Yorkie Rescue | Humane Society | ASPCA | Crohn's-Colitis America


0.547RCU1